Author Side stand Cut out switch  (Read 2029 times)

0 Members and 1 Guest are viewing this topic.

  • Offline Jake69

    • Crossrunner Member  ‐    32
    • **
    • Topic Author

    Offline Jake69

    • Crossrunner Member
    • **
    • Topic Author
    • Posts: 32
    • Bike: 2015 Crossrunner
    • City / Town: Newcastle
    • Country: England
    Side stand Cut out switch
    on: April 19, 2018, 05:40:37 pm
    April 19, 2018, 05:40:37 pm
    Hi..has anyone had any bother with the side stand cutout switch....today when I was out the bike would not start I did all the usual checks kill switch,stand down ,in gear ....then I wiggled the switch and pushed the connector and it started ....anyone got any advice please.......thanks

    ps its a 2015 CR..

  • Offline Bruggen

    • Crossrunner Pro  ‐    210
    • ***
      #1

    Offline Bruggen

    • Crossrunner Pro
    • ***
    • Posts: 210
    • Bike: Crossrunner 2016
    • City / Town: Redhill
    • Country: UK
    Re: Side stand Cut out switch
    Reply #1 on: April 22, 2018, 07:59:17 pm
    April 22, 2018, 07:59:17 pm
    I'd pull the connector and make sure that it's all clean, if not clean it. If that all appears to be OK it may be a problem with the switch, in which case I'd fit a new one for peace of mind, not cheap £90.96, but it means carrying a spare bit of cable with some connectors on to connect the two wires together in case of total failure.

  • Offline Jake69

    • Crossrunner Member  ‐    32
    • **
    • Topic Author
    • #2

    Offline Jake69

    • Crossrunner Member
    • **
    • Topic Author
    • Posts: 32
    • Bike: 2015 Crossrunner
    • City / Town: Newcastle
    • Country: England
    Re: Side stand Cut out switch
    Reply #2 on: April 30, 2018, 08:11:09 pm
    April 30, 2018, 08:11:09 pm
    Thanks Bruggen...