Decided togive the end can a thorough clean with Chrome cleaner. Took the shroud off - lovely job - good as new.BUT

when trying to refit the shroud I managed to cross thread the bolt which screws into the bracket which is welded onto the can. I tested a bolt I found in me toolbox - no probs - threads OK. Unfortunately my smugness was short lived. The bolt then sheared as I (over) tightened it leaving the pre drilled bracket hole full of the remnants.

Now have choice of remove can (maybe new Gasket required when I refit) and drill out the bracket, or slice the bracket and remove top bit then "replace" with a seperate bracket which I will bolt on to remaining side section of the original bracket.
Am thinking I might get the shroud powder coated black while I am at it but just thought you should all share in my pain here guys. Lets here it for Joe...aaaawww.
